引入块内码元频数抽样的块内频数检测识别方案

为识别链路层比特流是否加密,以未加密与加密数据在随机统计特性上的差异为依据,利用随机性检测的方法对加密比特流进行识别.在不同比特流长度条件下对3种典型随机性检测方法的识别率进行了比较研究.针对3种检测方法均对长度较短的未加密比特流识别率较低的问题,在块内频数检测的基础上,提出了基于块内码元频数抽样的比特流预处理方案,以及块内频数检测最优分块长度选择方案,并对预处理方案对识别率的影响进行了分析.实验结果表明,提出的方案可以显著提高块内频数检测对未加密比特流的识别率.     

声表面波对汽油胶质含量响应特性的理论与实验研究

从理论上分析了沉积于压电基片表面的汽油胶质对声表面波（SAW）传播特性的影响,在此基础上参照国家标准规定的汽油胶质含量测定试验条件,基于自制的SAW传感器,实验研究了SAW对不同汽油胶质含量的响应特性.结果表明SAW传感器的中心频率及幅度随SAW传播路径上沉积胶质的含量变化表现出敏感且单调的变化规律,这一结果可为车用汽油胶质含量的快速检测提供参考.     

Damage visualization and deformation measurement in glass laminates during projectile penetration

Transparent armor consists of glass-polymer laminates in most cases. The formation and propagation of damage in the different glass layers has a strong influence on the ballistic resistance of such laminates. In order to clarify the course of events during projectile penetration, an experimental technique was developed, which allows visualizing the onset and propagation of damage in each single layer of the laminate. A telecentric objective lens was used together with a microsecond video camera that allows recording 100 frames at a maximum rate of 1 MHz in a backlit photography set-up. With this technique, the damage evolution could be visualized in glass laminates consisting of four glass layers with lateral dimensions 500 mm × 500 mm. Damage evolution was recorded during penetration of 7.62 mm AP projectiles with tungsten carbide core and a total mass of 11.1 g in the impact velocity range from 800 to 880 m/s. In order to measure the deformation of single glass plates within the laminates, a piece of reflecting tape was attached to the corresponding glass plate, and photonic Doppler velocimetry (PDV) was applied. With the photonic Doppler velocimeter, an infrared laser is used to illuminate an object to be measured and the Doppler-shifted light is superimposed to a reference light beam at the detector. The simultaneous visualization and PDV measurement of the glass deformation allow determining the deformation at the time of the onset of fracture. The analysis of the experimental data was supported by numerical simulations, using the AUTODYN commercial hydro-code.     

切向空气气流对激光辐照碳纤维复合材料的影响

实验研究了靶材表面存在和不存在切向空气气流时,975nm连续激光对碳纤维增强树脂基复合材料的辐照效应,发现切向气流的加载有利于激光对碳纤维复合材料的破坏.从理论上对激光辐照下碳纤维复合材料的破坏机理进行了初步分析,基于碳的氧化特性和氧化反应机理,推导了碳纤维的氧化速率方程.采用改进的光滑粒子方法,对激光辐照下复合材料树...     

如何估计软件的MTBF

软件剩余初始故障个数No、平均无故障时间MTBF、故障暴露率λ和软件运行的成功率θ等是衡量软件可靠性的重要参数.其中对高可靠性软件(包括军用软件等)MTBF是最重要的.传统的MTBF计算方法有2种一是计算发生故障的平均时间间隔二是通过软件可靠性模型进行估计.前者代价较大,后者不太准确.本文从软件的失败率入手研究软件的MTBF,这是一个比较贴近实际的方法.     

后方油库整体生存概率分析计算

针对我军后方油库特点,探讨了油库整体生存概率计算的基本思路和方法,分析了各类分项目标生存概率的计算方法,采用层次分析对后方油库各分项目标权值进行了详细分析计算,可为后方油库伪装防护效能评估提供依据。     

Optimal (τ, T) opportunistic maintenance of a k‐out‐of‐n:G system with imperfect PM and partial failure

The opportunistic maintenance of a k‐out‐of‐n:G system with imperfect preventive maintenance (PM) is studied in this paper, where partial failure is allowed. In many applications, the optimal maintenance actions for one component often depend on the states of the other components and system reliability requirements. Two new (τ, T) opportunistic maintenance models with the consideration of reliability requirements are proposed. In these two models, only minimal repairs are performed on failed components before time τ and the corrective maintenance (CM) of all failed components are combined with PM of all functioning but deteriorated components after τ; if the system survives to time T without perfect maintenance, it will be subject to PM at time T. Considering maintenance time, asymptotic system cost rate and availability are derived. The results obtained generalize and unify some previous research in this area. Application to aircraft engine maintenance is presented. © 2000 John Wiley & Sons;, Inc. Naval Research Logistics 47: 223–239, 2000     

线导鱼雷导引弹道的动力学分析

通过线导鱼雷常用导引方法—三点法、前置角法导引弹道的动力学分析 ,推导出不同方法下鱼雷旋回速率的解析表达式 ,并通过数字仿真对鱼雷线导导引弹道动力学特性进行探讨 ,明确了线导鱼雷导引弹道特性与导引方法之间的关系 .     

电磁干扰预测在频率方案选择中的应用

应用电磁干扰预测的原理 ,针对一体化通信指挥系统中 ,多部电台集中使用所带来的频率管理问题 ,进行了干扰多级预测 ,得出了保证电磁兼容性系统各电台之间应满足的频率间隔 ,提出了通信网中通信频率方案     

气体化学反应速率的 DSMC 方法

为预报化学反应过程,应用ＤＳＭＣ方法研究了双原子分子的离解反应,讨论了高温情况下（Ｔ～Ｅａ／ｋ）采用由实验测定得到的反应速率与气体温度间Ａｒｒｈｅｎｉｕｓ经验关系式的可靠性问题,分析了振动热非平衡效应对于离解反应速率的影响,给出了由ＤＳＭＣ方法得到的离解反应速率与气体温度的关系曲线。